Quiz on Virtual LAN Part-3

No Comments
Quiz on Virtual LAN

Network Hope Quiz: Quiz on Virtual LAN Part-3

This page of Network Hope Quiz contains a quiz on Virtual LAN Part-3. The quiz has all the instructions and syntax for the configuration of VLAN. The article VLAN configuration covers practical hands-on on configuring VLANs in layer-2 switch. Please have a look at the article Configure VLAN before appearing in this quiz.

Choose the most appropriate among the four options. If you find any question or answer wrong, please comment or mail to inform the Admin.

Category : Easy

Please leave a message if you have any unresolved queries, and also let me know if you liked the quiz.

Chapter:VLAN Configuration

Click on the correct answer for each question.

No negative marking and no time limit.

At the end check the score and correct your answer.

  • 1. The command for trunk port configuration is ____________


    A) interface trunk

    B) interface mode trunk

    C) interface f0/1 mode trunk

    D) switchport mode trunk

  • 2. TO assign IP address to a VLAN 10, you have to execute _______ command first.


    A) enter vlan 10

    B) vlan 10

    C) interface vlan 10

    D) mode vlan 10

  • 3. The command to create a new VLAN, VLAN 20 is _____________


    A) create vlan 20

    B) vlan 20

    C) new vlan 20

    D) create new vlan 20

  • 4. Command to show all the VLAN status is _____________-


    A) show vlan all

    B) show vlan

    C) show all vlan

    D) show interface vlan

  • 5. Which of the below is the correct syntax to enter the interface mode with interfaces f0/1, f0/2, f0/3, f0/11, f0/19, f0/20?


    A) interface f0/1-3,f0/11,f0/19-20

    B) interface range f0/1-3 & f0/11 & f0/19-20

    C) int range f0/1-3,f0/11,f0/19-20

    D) int range f0/1-3,11,19-20

  • 6. Command from interface config mode to add interface(s) to VLAN 10


    A) switchport access vlan 10

    B) interface add vlan 10

    C) switchport add vlan 10

    D) interface access vlan 10

  • 7. Command to save the configuration.


    A) save memory

    B) copy start run

    C) save run start

    D) write memory

  • 8. Command to view trunk port ?


    A) show trunk port

    B) show trunk

    C) show interface trunk

    D) show trunk interface

  • 9. To allow VLAN 10 in trunk interface without affecting the other VLANs, you probably run this command.


    A) switchport mode trunk allowed vlan add 10

    B) interface trunk allowed vlan 10

    C) switchport trunk allowed vlan add 10

    D) interface trunk allowed vlan add 10

  • 10. To allow VLAN 10 in trunk interface and disallow all other VLANs, the command is ________


    A) switchport trunk allowed vlan only 10

    B) switchport trunk allowed vlan 10

    C) switchport trunk allowed vlan 10 remove all

    D) switchport trunk allowed vlan 10 disallow all



Click on the correct answer for each question.


No negative marking and no time limit.



To take another Quiz, Go back to Quiz Home >>




 šŸ Go back to Quiz Home

Share this article.


Comments

No comments yet. Why don’t you start the discussion?

Leave a Reply

Your email address will not be published. Required fields are marked *